Hi

I have just started using 911 CD Builder (version 2.06RC)
I don't know what has happened - I have used the CD Builder without problems.
I found that one of the programmes on the produced CD-ROM had a fault.
I corrected the fault (with ERD Commander).
When I tried creating a new ISO (after deleting the original) the wizard fails at the end with the message
"Operation Aborted"
"Couldn't access destination ISO File"

Any ideas??

Please see the following threads for possible solutions: here, here, and here. Also, see if this particular post could help.

CWP

Thanks for the help. Unfortunately none of the previous posts helped - I was trying to save to d:\911CD.ISO therefore no spaces in the directory name.

I seem to have fixed it by trial and error - I may have had problems with the MFT which was causing the error.
I can only assume that this was the cause as all seems OK now after running CHKDSK on the D: partition (it did find and fix quite a few errors).